New Products from KayJayCo

Company Info	Technical Info	Tools	New Products	Kits & Controllers
125°C Wire & Battery Cable	Connectors & Terminal Blocks	Cable Coverings	Fuses & Fuse Holders	Chemicals & Tapes
Switches	Relays	Crimp Terminals	Cable Clamps & Ties	Shopping Cart

NEW PRODUCTS

We look for products that are the best of class.

If we feel that they also offer an unusual value or capability, then we try them out and,
if they meet our standards, we offer them to you.

We are proud to announce these new products, in stock now!

Terminal Blocks
These terminal blocks are the most rugged, reliable, and (at 4.72 inches for 20 connections), compact we've been able to find. The time savings and reliability improvement over a conventional crimp and screw terminal, terminal strip is pretty phenomenal. And, of course, the connection may be disconnected and reconnected without damaging the wire. We are offering them in 4,6,8,12,16,& 20 connection strips.

Click HERE to go to the Connectors & Terminal Blocks page to order.

Self-Closing Split Braided Sleeving
This sleeving is a new product from Flexo-Wrap which combines the advantages of both split loom and braided PET sleeving. It holds itself shut like split loom and wires can be added and removed and branched out like split loom, but it is more flexible and much easier to work with. It goes around tight corners without buckling or opening up. It is more abrasion resistant, but has less "cushion" than split loom.

Click HERE to go to the Cable Coverings page to order.

Chemicals from ZEP
We're offering products from ZEP, Inc., because they're not available to the individuals and small shops that we serve, but are normally sold only to large commercial operations. Places like marine engine facilities and the Caterpillar service shop in Stockton, CA., for example, buy the ZEPRESERVE by the 55 gallon drum.
Why? Because it is the most effective penetrant/rustbuster on the planet. It puts everything else to shame.

We first ran into ZEPRESERVE when, after 7 frustrating hours of trying, we couldn't remove a 1-1/4" pipe nipple, part of the exhaust system, from a cylinder head on a Yanmar marine diesel that had been in operation on salt water for 12 years. Even when using a 36" pipe wrench with a cheater bar, WD-40, LPS-1, acetylene torch for heat, etc. It would NOT budge! It was seriously rusted into place.

Finally we pulled the head, and took it to a marine engine shop. The old veteran mechanic applied the Zep, tapped on it a few times, waited 15 minutes, and then unscrewed it! With a 12" pipe wrench! We have since tested other ZEP products, and found them to be outstanding. But they don't sell their products in retail stores. So that's why we're offering them. Why should only the big guys get the good stuff?

Oh, by the way, we're offering some other stuff too.

Click HERE to go to Chemicals page to order.